1.Change Bit: Pull the collet ring outwards. Insert the screw bit.  Then, release the collet ring, and the bit will automatically lock into  position.

2.Torque Adjustment: Twist the torque nut toward higher numbers on the torque scale for higher torque.  Twist toward lower numbers for lower torque.  (The numbers on the scale are for reference purpose only.  The true torque output can only be measured by a torque tester.)

3. Plug the Screwdriver into the Electricity Source Socket.  (Make sure the voltage is correct.)

4. Tightening the Fastener:

(1) PUSH AND LEVER COMBINATION FUNCTION (Put the switch on the PL position)

Push-start Mode:

Squeeze the trigger, make sure to keep the tool bit straight onto the fastener.  Then, push to start to tighten the screw.  As soon as the preset torque is reached, the tool stops automatically.  The tool is ready to drive next screw. 

Level (Trigger) Start Mode:

Apply axial pressure through the tool onto the fastener.  Then, squeeze the trigger to start to tighten the fastener.

(2) PUSH START FUNCTION (Put the switch on the P position)

Make sure the bit straightly engage the screw.  Then, push to start to tighten the screw. (It is the same as PL Function.  It is not necessary to squeeze the trigger.)

5. Untightening the Fastener:

If fastener is not properly seated, change the FORWARD/REVERSE selector to REVERSE position.  Then, do the same operations as to tighten the fastener (Item 4).

6. Do not change the setting FOR/REV. while the motor is running, or permanent damage to the motor will happen.

7. Keep the tool properly maintained:

Change the carbon brushes and lubrication annually, and our tool will give you many years of reliable  services.

SPECIFICATIONS ARE  SUBJECT TO CHANGE WITHOUT NOTICE.

GOLNEX, INC.

46953 Ocotillo Ct.

Fremont, CA 94539 U.S.A.

TEL:(510) 490-6003

FAX:(510) 490-6330